DATACARD IMAGECARD DRIVER DOWNLOAD

Configure the ECP parallel port 1 Close all open applications. Use only one data cable to connect the printer and PC. It is located on a label of the printer. Remove the diskette and insert the next diskette when prompted. Inside the printer Open the cover to find the following on the inside of the printer.

Uploader: Dull
Date Added: 26 October 2007
File Size: 61.32 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 6706
Price: Free* [*Free Regsitration Required]

Lift the swing arm until it is fully open step 2 in Figure You can load cards when the printer power is on or off. Each hidden character reduces, by one, the number of characters you can encode.

Ports dialog box 4 Select the Settings button to display the port settings. Make sure the locking tabs are in place. You must connect the printer and the PC after the printer is powered on and ready.

Other areas of the printer, such as a magnetic stripe module, duplex module, or specific rollers, might need cleaning from time to time. E E If the selections you want to use are not available are grayed outmake sure the feature is available in the printer.

In some circumstances, the printer might beep and the status light blink amber without a message appearing on the PC.

  COMPRO VISTA M1F/M2F TV CAPTURE DRIVER

DataCard ImageCard series Manual

Click Next to continue with installation. Press the cable connector all the way onto the port, and then turn the posts to secure the cable to the PC. The program continues to run. The Status Monitor is active and communicating with the printer. Regulatory Compliance Please do not attempt to operate or repair this equipment without adequate training.

Ready button The Ready button allows you to pause the printer while printing a card, to clear an error condition, to cancel a print job and delete all data for the job, or to create a printer test card.

– Datacard SELECT ImageCard Platinum Plastic ID Card Printer

Open the cover 2 Press down on the swing arm until it clicks step 1 in Figure If you make changes, or if this is the first time you have viewed the Document Default Properties dialog box, click OK to save the settings and close the dialog box.

After removing the printer driver, run the Cleanup utility which is on the driver CD. The replaceable cleaning sleeve is also available as part of a cleaning kit. Call for service if: Starting or quitting advanced setup The Advanced Setup button on the Status Monitor changes the printer driver from printing mode to advanced setup. Driver installation is complete: A setting of Edge-to-Edge is the same as a margin of 0. See Windows help for more information.

  BELKIN F5D8053 XP DRIVER

This section describes the printer parts you can order. E-1 Driver installation for Windows only.

The printhead intensity is too high. Press the power button to power off the printer 3 4 i Follow your policy to secure unprinted card stock, supplies, and printed cards. Don’t have an account?

C-5 Setting parallel port values. Run the installation again.

Datacard ImageCard Magna Badge Card Printer ICM OPT | eBay

Possible Cause Action You have clicked the Cancel button when the custom installation program was installing information and links. Cleaning the printhead Imagscard printhead can have contamination stuck to it. Card bow must be less than the thickness of the card.

Datacard Alcohol Cleaning Pen. Also make sure that the printer is powered on and connected to the PC and resume the Status Monitor.